|
|
|
National Stock Number:
5315-01-361-3457
Federal Supply Class:
5315
National Item Identification Number:
013613457
Description:
PIN,GROOVED,HEADLESS
Detail:
A headless item of various shapes, usually cylindrical, having either circular or longitudinal groove(s). Its length must not exceed 12 inches (304 MM). Excludes ROD, GROOVED, HEADLESS; SHAFT (as modified); and PIN, VEHICULAR LEAF SPRING SHACKLE.
|
Manufacturer Information:
| 183196-3 | 71791 | CURTISS-WRIGHT CONTROLS, INC. |
|
Techincal Specification:
| EFFECTIVE LENGTH | 0.587 INCHES MINIMUM AND 0.587 INCHES MINIMUM AND 0.603 INCHES MAXIMUM0.603 INCHES MAXIMUM | | DIAMETER | 0.2587 INCHES MINIMUM AND 0.2587 INCHES MINIMUM AND 0.2591 INCHES MAXIMUM0.2591 INCHES MAXIMUM | | FIRST END STYLE | CHAMFEREDCHAMFERED | | FIRST END TAPER ANGLE | 42.5 DEGREES MINIMUM AND 42.5 DEGREES MINIMUM AND 47.5 DEGREES MAXIMUM47.5 DEGREES MAXIMUM | | FIRST END TAPER LENGTH | 0.020 INCHES MINIMUM AND 0.020 INCHES MINIMUM AND 0.040 INCHES MAXIMUM0.040 INCHES MAXIMUM | | FIRST END LOCATION | BOTH ENDSBOTH ENDS | | OVERALL LENGTH | 0.830 INCHES MINIMUM AND 0.830 INCHES MINIMUM AND 0.840 INCHES MAXIMUM0.840 INCHES MAXIMUM | | SECOND END RELATIONSHIP WITH FIRST END | IDENTICALIDENTICAL | | SECOND UNDERCUT WIDTH | 0.031 INCHES MINIMUM AND 0.031 INCHES MINIMUM AND 0.034 INCHES MAXIMUM0.034 INCHES MAXIMUM | | STYLE DESIGNATOR | GROOVEGROOVE | | SPECIAL FEATURES | SHOT PEEN PER MIL-S-13165 USE S-170 SIZE HARD SHOT (RC 55-65) TO AN INTENSITY OF .012-.015A. 200 PERCENT COVERAGE REQUIRED. 100 PERCENT COVERAGE TO BE DETERMINED BY VISUAL EXAMINATION AT 10 TIMES MAGNIFICATION. PEENING PROCEDURE MUST BE APPROVED BY CWFS ENGINEERING. DIMENSIONS APPLY BEFORE SHOT PEENING,PLATING AND AFTER HEAT TREAT. DO NOT SHOT PEEN ON BOTH ENDS TO WITHIN.120-.150 OF BOTH ENDS. ITEM IS CADMIUM PLATED OR CHROMATE TREATEDSHOT PEEN PER MIL-S-13165 USE S-170 SIZE HARD SHOT (RC 55-65) TO AN INTENSITY OF .012-.015A. 200 PERCENT COVERAGE REQUIRED. 100 PERCENT COVERAGE TO BE DETERMINED BY VISUAL EXAMINATION AT 10 TIMES MAGNIFICATION. PEENING PROCEDURE MUST BE APPROVED BY CWFS ENGINEERING. DIMENSIONS APPLY BEFORE SHOT PEENING,PLATING AND AFTER HEAT TREAT. DO NOT SHOT PEEN ON BOTH ENDS TO WITHIN.120-.150 OF BOTH ENDS. ITEM IS CADMIUM PLATED OR CHROMATE TREATED | | UNDERCUT DIAMETER | 0.2285 INCHES MINIMUM AND 0.2285 INCHES MINIMUM AND 0.2315 INCHES MAXIMUM0.2315 INCHES MAXIMUM | | UNDERCUT WIDTH | 0.031 INCHES MINIMUM AND 0.031 INCHES MINIMUM AND 0.034 INCHES MAXIMUM0.034 INCHES MAXIMUM |
|
|